NECA 1/4 Stand Kit
1
1: Place the base on a flat even surface
2
2: Fit the front pillar "A" into the main pillar slots on either side of the main pillar is ok
3
3: Holding the main pillar and front support pillar "A" push them down into the base slots make sure they are all the way down firmly
4
4: Slide in the back pillar "B" into the slots of the main pillar
5
5: If the pillar tabs don't line up pull back slighty on the main pillar to line up the slots with the tabs on the "B" pillar support then fit them in
6
6: Fit the oval pillar brace as shown in the picture with the longest cutout goes down over the "A" pillar or front pillar
7
7: Fit the oval brace as far down as possible​
8
​​​8: Turn the stand on its side then slide in the pillar brace bar through the slot at the bottom of the "A" pillar support to its center position
9
9: While holding the pillar brace bar on the other side of the base, screw in the two 10mm M3 bolts through the holes at the bottom of the base up through the holes of the pillar brace bar on the other side
10
10: The two bolts should come through the pillar brace bar as shown in the picture
11
11: Make sure the base is still on its side then fit the two M3 nuts to the bolts sticking up.To do this use one finger to hold the nut on the bolt with your left hand and the other hand to screw the bolt underneath the base with the screwdriver.
13
13: The main pillar has now been secured you can insert the adjustable leg support.Insert this like a key, first as shown above
12
12: Secure the nuts to a finger tight position then use the provided 3d printed wrench tool to tighten further.DO NOT OVERTIGHTEN IT JUST ENOUGH TO SECURE.You may need to use the screwdriver again to hold the bolt under the base
14
14: Turn the leg support 90 degree once you have it inserted far enough to secure it to the slot as shown
15
15: Fit the main bar support to the correct holes according the fitting guide located at the bottom of this page or on your leaflet instructions in your shipping parcel
16
16: Use the included 15mm M3 bolts to secure the bar to the main pillar
17
17: Carefully place your figure down over the main bar until the feet are down correctly on the base
18
18: The V-Bar is designed to prevent the figure from moving forward.Positon the legs on the figure correctly stanced and make sure the figure is forward up against the V-Bar
19
19: Adjust the leg support bar to sit up against the legs under the bottom area.This secures the back and clamps the figure.
20
20: Tighten the screw to lock the leg support bar once its up against the legs.It doesn't matter if its not 100% hitting the legs but it must be as close as possible.
21
21: Double check the figure is standing straight upright.The figure should be standing roughly in the center of the base area.If its leaning make adjustments.
22
22: The logo has been fitted in your base.If you want to remove it and make your own simply use the hole under the base and pop out the decal and acrylic cover.
23
23: The assembly is complete.Your figure is now supported from falling and gives a great display effect.
FITTING GUIDES
This is the fitting guide for the main bar placement under the figure.Make sure to use the correct holes in this guide for the perfect fit of your figure.
1989 BATMAN = Two bottom holes (lowest)
