1: Place the base on a flat even surface

2: Fit the front pillar "A" into the main pillar slots

3: Holding the main pillar and front support pillar push them down into the base slots make sure they are all the way down

4:Slide in the back pillar "B" into the slots of the main pillar

5: If the pillar tabs don't line up pull back slighty on the main pillar to line up the slots with the tabs and slide in and secure tightly.

6: Hold the oval pillar brace as shown in the picture with the longest cutout to the front

7: Fit the oval brace as far down as possible

8: Insert the main pillar brace bar

9: Holding the brace bar turn over the base and insert the two 10mm m3 bolts into the cutout holes under the base and screw in all the way

10: Fit the two nuts onto the bolts on top of the base and tighten as much as you can with your fingers.
11: Using the supplied 3D printed nut wrench flip the base so that one hand holds the nut wrench and the other can use the screwdriver to tighten.

12: Insert the two m3 nuts into the hex cutout holes on the holding mount only two bolts and nuts are required for this but you must insert them as shown so that they are diagonal (ie right top hole and left bottom hole or left top hole and right bottom hole)

13: Push the nuts all the way down with your screwdriver.

14: Insert the two longer m3 bolts through the back of the main pillar and using the rectangle handle end of the nut wrench that is included, insert it down the cutout hole of the nut to push it down and hold it there while tightening the m3 bolt. (nut wrench not shown in the picture)

15: The stand is ready for the figure.

16-18: Position the turtle over the mount and line up the the two mount prongs so that they slide just behind the turtle shell and on either side of the plastic figure part above the legs.(this is a green plastic bar between the legs).Note if the shell is hitting the mount and preventing the turtle figure from standing flat remove the mount and set it to the lower holes.Some figure shells are lower than others.Note: The new pillar is not shown but it has been updated with additional holes.

​

To change from the black engraved oval cutout to the logo, using your screwdriver simply push out the oval through the hole from under the base and insert the logo emblem printout and make sure its pushed in flat into the hole and insert the clear acrylic oval on top of the emblem and push down to sit flush with the top of the base.

Your stand is complete.